D,B,F,H,J series Titanium Intake/Exhaust Manifold Stud Kit
These Titanium Honda/Acura intake/exhaust manifold stud kits were designed in-house and manufactured specifically for Hiro’s Hotrods and FeltyFab. Designed with ease of install in mind, these have a 3.0MM Allen wrench opening in the end of each stud. It is important to upgrade your exhaust manifold hardware when adding an aftermarket manifold. Titanium does not rust or corrode like OEM steel hardware does. These stud kits will remain strong and look great for years. It is especially important to switch to titanium studs under high boost applications. The manifold must have a good seal on the head and your OEM hardware may become problematic with decades of corrosion, heat cycles, and normal wear and tear. Titanium is also 45% lighter than steel. This can contribute to a substantial weight savings when switching large amounts of OEM hardware over too Titanium.
Each Hiros Hotrods X FeltyFab Kit includes:
10 M8X1.25MMX45MM Studs
10 12MM 12 point M8 Flange Nuts
10 Matching M8 Washers
These Titanium Honda/Acura intake/exhaust manifold stud kits were designed in-house and manufactured specifically for Hiro’s Hotrods and FeltyFab. Designed with ease of install in mind, these have a 3.0MM Allen wrench opening in the end of each stud. It is important to upgrade your exhaust manifold hardware when adding an aftermarket manifold. Titanium does not rust or corrode like OEM steel hardware does. These stud kits will remain strong and look great for years. It is especially important to switch to titanium studs under high boost applications. The manifold must have a good seal on the head and your OEM hardware may become problematic with decades of corrosion, heat cycles, and normal wear and tear. Titanium is also 45% lighter than steel. This can contribute to a substantial weight savings when switching large amounts of OEM hardware over too Titanium.
Each Hiros Hotrods X FeltyFab Kit includes:
10 M8X1.25MMX45MM Studs
10 12MM 12 point M8 Flange Nuts
10 Matching M8 Washers
These Titanium Honda/Acura intake/exhaust manifold stud kits were designed in-house and manufactured specifically for Hiro’s Hotrods and FeltyFab. Designed with ease of install in mind, these have a 3.0MM Allen wrench opening in the end of each stud. It is important to upgrade your exhaust manifold hardware when adding an aftermarket manifold. Titanium does not rust or corrode like OEM steel hardware does. These stud kits will remain strong and look great for years. It is especially important to switch to titanium studs under high boost applications. The manifold must have a good seal on the head and your OEM hardware may become problematic with decades of corrosion, heat cycles, and normal wear and tear. Titanium is also 45% lighter than steel. This can contribute to a substantial weight savings when switching large amounts of OEM hardware over too Titanium.
Each Hiros Hotrods X FeltyFab Kit includes:
10 M8X1.25MMX45MM Studs
10 12MM 12 point M8 Flange Nuts
10 Matching M8 Washers